INSTALLATION AND SETUP
Extra Video
Optional Inputs
2-8
If you want to use an extra video source in addition to the video source(s) connected
at
or
connect either a Composite or S-video source to
INPUT 3
INPUT 4
shown.
NOTES: 1) Do not simultaneously connect Composite and S-video to
can switch between video sources connected at
3) Extra video is only available with models that have a BNC connector at
and will not work with previous Christie models, which include a RCA connector at
.
INPUT 3
Figure 2.11. Connecting an Extra Video Source to Input 1
Optional input modules allow you to increase your total number of inputs and/or
accommodate different signal types, whether analog or digital. Install in the areas
labeled
or
INPUT 5
INPUT 6.
•
RGB 500 Input Module
•
RGB 400 Active Loop Thru Input Module
•
RGB 400 Buffered Amplifier Input Module
•
PC250 Analog Input Module
•
Serial Digital Input Module
•
Digital HDTV Module
•
DVI Input Module
•
Dual SD/HD-SDI Module
For even more sources, connect a 3
RS422-compatible, to any of the three RS422 ports. Note that any sources in a
switcher can be selected only at the switcher, not via the keypad or TPC.
NOTES: 1) Connect analog HDTV signals directly to
"RGB" input module installed—the optional HDTV Input Module used in earlier
projectors is not needed or recommended. 2) See Appendix E, Optional Input
Modules for a brief description of each interface.
INPUT 1
These interfaces include:
rd
-party switcher to the RS232 IN port, or, if
INPUT 1
. 2) You
INPUT 1
and
or
INPUT 3
INPUT 4
INPUT 3
or to any other
INPUT 1
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
as
.