Christie CineIPM-2K User Manual page 12

INSTALLATION AND SETUP
RGB Signals
YPbPr Signals
(COMPONENT VIDEO)
2-6
consists of 5 BNCs (connectors) for linking to a variety of sources. The
INPUT 1
typical connection would be to an RGB source such as a PC, Mac, DEC, Sun, SGI
and others. The Cine-IPM 2K supports multiple sync types with RGB signals: sync-
on-green, composite sync, and separate H & V syncs.
NOTE: Depending on your source, you may need a custom adapter cable with BNC
connectors at the projector end and a different type of connector at the other (such as
a 15-pin "D" connector for some computer sources). Contact your dealer for details.
Connect the BNC input(s). Then connect the red, green and blue source outputs
SYNC
to the , , and
RED GREEN
on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the input labeled
SYNC
labeled See Figure 2.8.
VERT.
Figure 2.8. Connecting an RGB source
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify this Color Space option within the Image Settings menu. See 3.5,
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
sources–to , use the red, green and blue BNCs as described in YPbPr Signals
INPUT 1
(below). 3) This input does not route to the decoder and cannot be used for Composite
Video or S-Video.
Connect a YPbPr signal (component video) to
2.9.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.5, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
or . Use the appropriate optional digital interface installed in
1 INPUT 2
only. 3) With v1.1 software, digitally encrypted source material (HDCP) cannot be
processed and will be displayed as a blank screen.
BNCs on the
BLUE INPUT 1
and connect vertical sync to
HOR/COMP
INPUT 1
panel. If the source uses sync-
input labeled
SYNC HOR/COMP
SYNC
or as shown in Figure
INPUT 2
INPUT 5
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
. If
input
INPUT
or
6