Christie CineIPM-2K User Manual page 10

INSTALLATION AND SETUP
Step 5
C ontroller
STEP 6
STEP 7
STEP 8
2-4
NOTES: 1) Based on some monitor resolution limitations, Cine-IPM 2K output may
not be accepted. 2) For any installation, connect either DVI-1 or DVI-2 to a
compatible display device; output data is the same until 10-bit mode is activated. 3)
For complete information, such as how to connect for 10-bit operation, see 2.3,
Connecting DVI Outputs.
Connect Communications
All Cine-IPM 2K functions can be accessed and controlled using its keypad. Use the
keypad as an IR remote, or connect it to the Cine-IPM 2K's front input panel using
the keypad cable (wired configuration is required when the Cine-IPM 2K is
permanently hidden within the pedestal).
For the option of using
the CP2000's Touch
Panel Controller to
select Cine-IPM 2K
sources, you must also
connect the Cine-IPM
2K's RS232 "B" cable
(see right):
1. Connect the custom
RS232 cable
(provided) to the
port on rear
RS232 B
of the Cine-IPM 2K.
2. Connect the other end to the
2.4.
Do not use RS232 "B" ports and cable with other
equipment or in other configurations.
Connect to Power
Connect the Cine-IPM 2K power cord to the convenience outlet within the pedestal
(refer back to Figure 2.4), or to an external supply as desired. See Specifications for
power requirements.
Do not attempt operation if the AC level is not within
the specified range for the Cine-IPM 2K.
Turn on the Projector
Follow the complete power-up instructions provided in the CP2000 User's Manual.
Turn on the Cine-IPM 2K
At the front of the Cine-IPM 2K, set the "Power" switch to
(power) on the remote keypad.
Figure 2.6. Connecting Communication to TPC
port on the CP2000. Refer back to Figure
RS232 B
IMPORTANT
WARNING
. Then press
ON
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)