Image Optimization - Christie CineIPM-2K User Manual

Working with Switching
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
NOTE: Disable PIP for Interlaced sources > 35kHz.
PIP Size and Position –
Controls in the PIP Size and
Position menu affect the PIP
(secondary) image, functioning in
the same manner as the main
controls in the Size and Position
menu—see 3.5, Adjusting the
Image for descriptions.
Additional options unique to the
PIP image are:
–Set the
POSITION PRESETS
location of the PIP (secondary)
image in the display.
ASPECT RATIO PRESETS
"Default" or "Anamorphic". Refer back to 3.5, Adjusting the Image (Resize Presets)
for details.
PIP Image Settings —
Adjust the PIP (secondary image) without affecting the size or position. The primary
image remains unchanged. See 3.5, Adjusting the Image for details.
PIP Border Width
Set the desired line thickness for your PIP window border.
PIP Border Color
Select the desired color for the PIP window border.
Switching is the ability to instantly and/or smoothly switch sources, and is controlled
with options 7 and 8 in the PIP and Switching menu. To use Switching, PIP must be
disabled and the Cine-IPM 2K output set to a resolution that is less than 1920 x 1080.

Image Optimization

Choose whether to switch sources as smoothly as possible, or whether you prefer to
optimize image quality, whichever best suits your needs. Select "Best Image Quality"
to improve raw image quality while maintaining 10-bit processing; however in some
cases when switching between sources, you may notice a brief dark state between
images. Select "Smooth Switching" to maintain the ability to frame lock. This is best
suited for when switching between video sources. In some instances, you will notice
a brief dark state between images. If you are not concerned with frame locking select
"Seamless Switching. This will set the output to a fixed frame rate (60Hz). Switching
occurs almost instantaneously without a dark state in between images. NOTE: With
Smooth and Seamless Switching, Cine-IPM 2K output must be less than 1920 x 1080.
Fade Time
Set how long (in seconds) it takes to gradually dissolve one image into another for a
source switch. Fading is available for single-image "best" source switching only—
PIP cannot be in use, and Image Optimization must be set to "Smooth Switching".
SUBMENU
– Set the desired aspect ratio of your PIP image to
SUBMENU
OPERATION
3-47