Christie CineIPM-2K User Manual page 32

OPERATION
3-6
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Input 2
Press to display from the DVI source (analog or digital) connected to
Input 2
PIP is enabled, pressing this key will change the PIP source.
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
enabled, pressing this key will change the PIP source.
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
enabled, pressing this key will change the PIP source.
Input 5
Input 5
Press to display from the
Input 5
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, with two inputs connected to it, the second input (B) is
considered
INPUT 7.
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 5
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
Input 6
Input 6
Press to display from the
Input 6
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, and there are two inputs connected, its second input (B)
is considered
INPUT 8
•
While displaying from
•
While displaying from any input other than the Dual SD/HD-SDI Module,
press . This switches to either
Input 6
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
to display from the other Dual SD/HD-SDI Module input.
Contrast
Cont
Press to change the amount of white in your images. Use
Cont
you reach the desired level of white—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., "crushed"). Conversely, low contrast causes dim images. See 3.5
Adjusting the Image (Image Settings subsection).
Brightness
Bright
Press to increase or decrease the amount of black in the image. Use
Bright
keys until you reach the desired level of black—for best results, start high and
interface module installed in the Option 1 slot.
INPUT 5
Use to access
INPUT 5 INPUT 7
, press
INPUT 5
INPUT 5
interface module installed in the Option 2 slot.
INPUT 6
. Use to access
INPUT 6
, press
INPUT 6
INPUT 6
INPUT 3
. If PIP is
INPUT 4
as follows:
again. This switches to
Input 5
or , depending on which of
INPUT 7
as follows:
INPUT 8
again. This switches to
Input 6
or , depending on which of
INPUT 8
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
.
INPUT 1
. If
INPUT 2
. If PIP is
.
INPUT 7
again
Input 5
.
INPUT 8
again
Input 6
keys until