Remote Keypad Commands - Christie M-Series User Manual

Section 3: Operation
• Power Key, used to switch from Standby mode to ON, and from ON to Standby mode; LED always remains
Amber
• Help Key, only available in the On Screen Display (OSD) context; LED is Amber when the menu is being
displayed on the projected image display; when no menu is being displayed, the Help key is still enabled if
the OSD is enabled. It is only disabled when the entire OSD is set to OFF.
• Auto Key, enabled state when the power is on and there are no test patterns on the screen. If the power is off
or a test pattern is displayed the Auto key is disabled.
• Exit Key, is determined in the specific context of the screen being displayed.
• Input Key, enabled when the power is on. Disabled if the power is off.
• Lens Key, enabled when the power is on. Disabled if the power is off.
• Shutter Key, enabled when the power is on. Disabled if the power is off.
• Menu Key, always remains in the enabled state when the power is on. If the power is off the Menu key is dis-
abled.
• Soft Key, used to select an action indicated by text above the key on the LCD. If no text is shown, the asso-
ciated key is disabled.

3.1.1 Remote Keypad Commands

Specific keypad commands are explained, see
Power ON/OFF
Press and hold P
release P
OWER
correct action (useful if you are unsure of the present state). NOTES: 1) After powering down, the lamp
cooling fan remains on for approximately five minutes to cool the lamp. 2) Avoid turning the projector back on
until it has been off for a few minutes. Hot re-strikes of the lamp will reduce lamp life.
Test
Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to
current input.
Press T and then cycle by using the U
EST
direction through the test patterns. Press E
Auto
Initiates an automated process in which the projector optimizes critical display parameters such as size,
position, pixel tracking, etc., for the current source. These parameters are listed in
auto setup can save time in perfecting a display and you can modify the adjustments as desired.
3-4
for two seconds or press twice quickly to action the projector ON or OFF. Or press and
OWER
followed immediately by U
Figure 3-1 - Remote
(ON) or D
A K
P RROW EY
and D
A K
P RROW EY OWN
to return to the current input.
XIT
Keypad:
(OFF) to guarantee the
A K
OWN RROW EY
arrow keys, to cycle in either
A K
RROW EY
Table 3.1 - Auto
020-100009-02 Rev. 1 (04-2009)
Setup. An
M-Series User Manual