Christie CineIPM-2K User Manual page 116

OPTIONAL INPUT MODULES
PC250 Analog
Input Module
38-804609-xx
DVI Input Module
38-804635-xx
Serial Digital Input Module
38-804602-xx
E-2
RGB400ALT Features
◊
accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync, or
separate horizontal and vertical sync)
◊
BNC connectors for RGB signal inputs
◊
buffered loop-through video outputs
This module receives analog RGB input signals from IBM PC compatibles or
Macintosh computers. Video inputs are 75
buffered loop-through to another display device.
PC250 Analog Features
◊
accepts VGA or MAC RGB video
◊
15 pin D connectors for video
◊
active loop-through video outputs
NOTE: This interface does not accept VGA and MAC signals simultaneously.
This module can display digital video input signals conforming to the DVI (Digital
Visual Interface) single-channel standard.
Features
◊
Supports Digital Visual Interface (DVI) single-channel
◊
Supports VESA® Extended Display Identification Data (EDID™)
◊
Provides an active-loop-through using a DVI connector (conforming to
the DVI Specification)
This module accepts a serial digital 4:2:2 component video signal (YCbCr) via a
single BNC connector. The signal can loop through the
SERIAL IN
out to another device (such as another Cine-IPM 2K / CP2000). Inputs are 75
terminated.
Σ
terminated. Outputs are provided for
Cine-IPM 2K User's Manual
BNC
SERIAL OUT
Σ
020-100164-01 Rev. 1 (01/08)