Remote Keypad Commands - Christie M Series User Manual

Section 3: Operation
• Help Key, only available in the On Screen Display (OSD) context; LED is Amber when the menu is being
displayed on the projected image display; when no menu is being displayed, the Help key is still enabled if
the OSD is enabled. It is only disabled when the entire OSD is set to OFF.
• Auto Key, enabled state when the power is ON, and there are no test patterns on the screen. If the power is
OFF or a test pattern displays, the Auto key is disabled.
• Exit Key, is determined in the specific context of the screen being displayed.
• Input Key, enabled when the power is ON. Disabled if the power is OFF.
• Lens Key, enabled when the power is ON. Disabled if the power is OFF.
• Shutter Key, enabled when the power is ON. Disabled if the power is OFF.
• Menu Key, always remains in the enabled state when the power is ON. If the power is off the Menu key is
disabled.
• Soft Key, used to select an action indicated by text above the key on the LCD. If no text is shown, the
associated key is disabled.

3.1.1 Remote Keypad Commands

Specific keypad commands are explained, see
Power ON/OFF
Press and hold P
release P
OWER
correct action (useful if you are unsure of the present state).
fan remains on for approximately five minutes to cool the lamp.
has been off for a few minutes. Hot re-strikes of the lamp will reduce lamp life.
Test
Steps forward through all internal test patterns. After stepping past the last test pattern, you will return to
current input.
Press T and then cycle by using the U
EST
direction through the test patterns. Press E
Auto
Initiates an automated process in which the projector optimizes critical display parameters such as size,
position, pixel tracking, etc., for the current source. These parameters are listed in
auto setup can save time in perfecting a display and you can modify the adjustments as desired.
Table 3.1 Auto Setup
You must have an unlocked channel present to use Auto Setup.
NOTE:
3-4
for two seconds or press twice quickly to action the projector ON or OFF. Or press and
OWER
followed immediately by U
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
Figure 3-1 Remote
(ON) or D
A K
P RROW EY
NOTES: 1)
2)
and D
A K
P RROW EY OWN
to return to the current input.
XIT
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
Keypad:
(OFF) to guarantee the
A K
OWN RROW EY
After powering down, the lamp cooling
Avoid turning the projector back on until it
arrow keys, to cycle in either
A K
RROW EY
Table 3.1 Auto
020-100009-04 Rev. 1 (10-2009)
Setup. An
M Series User Manual