Remote Control Of The Cine-Ipm 2K - Christie CineIPM-2K User Manual

3.10 Remote Control
of the
Cine-IPM 2K
Cine-IPM 2K User's Manual
020-100164-01 Rev. 1 (01/08)
Figure 3.27. "Input" Location and Cine-IPM 2K Source Selection
WHEN THE REMOTE KEYPAD IS REQUIRED
or if you are using 10-bit mode, you must use the remote keypad for selection
DVI-2
of the specific input#—i.e., you cannot select a specific Cine-IPM 2K input 1-6 at the
TPC Main menu.
• If connected via
port cannot be identified by its input number (1-6). The button must be
configured simply as "DVI-2" input in the Custom menu. When this button
is selected, you must then use the remote keypad to select
, or
Input 4 Input 5 Input 6
• If using 10-bit mode: The TPC button must be configured as "DVI-TWIN"
input in the Custom menu, otherwise you will not be in 10-bit mode. When
the button is pressed, you must then use the remote keypad to select
, ,
Input 3 Input 4
Input 2
As an alternative to using the keypad, Cine-IPM 2K functions can be controlled
remotely, typically at a controller such as a PC, via 1) simple bi-directional ASCII
messaging on a serial or Ethernet communication link or 2) a web interface or
"ChristieNET" on an Ethernet network.
VIA ASCII MESSAGING —
controller and the
RS232 IN
Alternatively, open an Ethernet socket—such as Telnet—between your controller and
the valid Cine-IPM 2K address. Valid ASCII codes and messages are documented in
the Christie Serial Communications document available at the Christie website.
VIA WEB INTERFACE —
web browser (Internet Explorer, for example), enter the IP address of the Cine-IPM
2K. This will start a password-protected ChristieNET application—enter the factory
default " " login and password to open the program. If the Cine-IPM 2K is
ccm7
powered up, you can access assorted menu options and slidebars.
Repeat for remaining networked Cine-IPM 2Ks as desired. Keep in mind that
multiple units can be controlled from one PC, but each unit will be in its own
ChristieNET interface (web browser) at the PC. Likewise, you can make up to five
separate web locations to a single Cine-IPM 2K.
: If your Cine-IPM 2K is connected via
: Cine-IPM 2K output arriving at the CP2000
DVI-2
as desired.
, or as desired.
Input 5 Input 6
Connect a serial link (recommended) between your
port (or , if available from your controller).
RS422
Connect your PC to the Cine-IPM 2K's Ethernet port. In your
OPERATION
DVI-2
, , ,
Input 3
Input 1 Input 2
,
Input 1
3-49