Tps Adjustment - Suzuki DL1000 Service Manual

CODE MALFUNCTION PART
None
C00
C11 Camshaft position sensor (CMPS)
C12 Crankshaft position sensor (CKPS)
C13 Intake air pressure sensor (IAPS)
C14 Throttle position sensor (TPS)
C15 Engine coolant temp. sensor (ECTS)
C21 Intake air temp. sensor (IATS)
C22 Atmospheric pressure sensor (APS)
C23 Tip over sensor (TOS)
C24 Ignition signal #1 (IG coil #1)
C25 Ignition signal #2 (IG coil #2)
C28 Secondary throttle valve actuator (STVA)
C29 Secondary throttle position sensor (STPS)
C31 Gear position signal (GP switch)
C32 Injector signal #1 (FI #1)
C33 Injector signal #2 (F1 #2)
C41 Fuel pump control system (FP control system)
C42 Ignition switch signal (IG switch signal)
C44 Heated oxygen sensor (HO
In the LCD (DISPLAY) panel, the malfunction code is indicated from small code to large code.
*3
When the secondary throttle valve actuator and secondary throttle position sensor signals are not sent to
ECM. C29 is indicated.

TPS ADJUSTMENT

1. Adjust the engine rpm to 1 200 ± 100 rpm. (#2-14)
2. Stop the engine and connect the special tool (Mode select
switch) to the dealer mode coupler at the wiring harness.
3. If the throttle position sensor adjustment is necessary, loosen
the screws and turn the throttle position sensor and bring the
line to middle.
4. Then, tighten the screws to fix the throttle position sensor.
! 09930-11950: Torx wrench
Incorrect
Position correcte
Incorrect
The LCD indicates 0.4 sec./time.
The correct position must be determined when the middle line is
indicated twice or more, where the sensor should be fixed.
No defective part
Pick-up coil signal, signal generator
For #1 cylinder
For #2 cylinder
*3
For #1 cylinder
For #2 cylinder
Fuel pump, Fuel pump relay
Anti-theft
S)
2
FI SYSTEM
REMARKS
4-25