Example Of Dcp Control - NTI SPLITMUX-DVI-4RT Installation And Operation Manual

OSD - SYSTEM - CONTROL

Example of DCP control

A SPLITMUX is controlled via DCP-XML by a computer connected by serial cable or USB.
For an introduction to the DEVICE CONTROL PROTOCOL please Annex.
DCP synchronize
Use this mode to keep several SPLITMUX
devices in the same mode.
Every change in settings initiated in the first SPLITMUX
by hotkeys, hotmouse, front panel buttons or
controlling devices synchronizes the
modes of all connected devices via DCP messages.
Use special Y-cables for the synchronization.
Important:
Each time you restart a SPLITMUX set to synchronize, it will send all its settings to the next
connected device. This process also takes place after activating synchronize in the OSD menu.
When starting a chain of devices, always start by first switching on the device at the end of the chain.
When the device has completed its startup phase and sent its DCP messages, switch on the next device
in the chain.
Finally, switch on the first device in the chain, which synchronizes the settings of all other devices in the
chain with its own settings as it starts up.
SPLITMUX - Installation and Operation Manual
USB or COM
ports
ON SCREEN DISPLAY
Computer
controls
DCP-XML
Rear Panel
2