Replacing The Front Bezel - HP Integrity rx6600 User's & Service Manual

Removal and Replacement
Removing and Replacing the Front Bezel
IMPORTANT You must reinstall the plastic server label into the replacement bezel.
Step 11. Slide the bezel to the right to release it from the chassis, and lift it off the chassis.

Replacing the Front Bezel

To replace the front bezel, follow these steps:
Step 1. Align the bezel slots with the tabs on the chassis.
Step 2. Slide the bezel from right to left to lock it into place.
Step 3. Tilt the bezel toward the chassis until it is flush with the chassis.
Step 4. Flip in the two pull handles located on both ends of the front bezel.
Step 5. Replace the four screws that attach the bezel to the right side of the chassis.
Step 6. Replace the four screws that attach the bezel to the left side of the chassis.
Step 7. Reinsert the plastic label with the notched end on the bottom, and push it into the slot in the bezel.
Step 8. Slide the processor board assembly into the chassis until it begins to seat into the socket located on
the midplane board.
Step 9. Push the processor board access door upward until it locks into position.
Step 10. Replace the memory carrier assembly. See "Replacing the Memory Carrier Assembly" on page 89.
Step 11. Replace the memory carrier assembly cover. See "Replacing the Memory Carrier Assembly Cover"
on page 61.
Step 12. Close the top cover release lever.
Step 13. If rack installed, slide the server completely into the rack. See "Inserting the Server into the Rack"
on page 57.
Step 14. Reconnect the power cables and power on the server. See "Powering On the Server" on page 51.
86
Chapter 4