Step 2. If rack installed, slide the server out from the rack until it stops. See "Extending the Server from
the Rack" on page 57.
Step 3. Unlatch the cover release lever on the top cover and remove the memory carrier assembly cover.
See "Removing the Memory Carrier Assembly Cover" on page 60.
NOTE
Step 4. Remove the memory carrier assembly. See "Removing the Memory Carrier Assembly" on page 87.
NOTE
Step 5. Locate the DIMM you need to remove. Use Figure 4-16, "48-DIMM Memory Carrier Board Slot
IDs".
Step 6. Lay the memory carrier assembly on side 0 or side 1 so that the memory board containing the
DIMMs that require servicing faces upward (Figure 4-14).
Step 7. Remove the memory carrier assembly side cover.
a. Press the release tabs (Figure 4-14) on both sides of the extraction handle release button until
the side cover releases from the top center of the assembly.
b. Rotate the side cover slightly to free the tabs from the retaining slots at the base of the
assembly (Figure 4-15).
c. Lift the side cover off the assembly.
Step 8. Release the DIMM from the slot.
a. Identify the DIMM you want to remove on the memory board.
b. Push the appropriate extraction levers found on either side of the DIMM slot outward to the
open position (Figure 4-17).
Step 9. Remove the DIMM from the slot.
Chapter 4
You do not need to fully remove the top cover to service this component; however, the
top cover release lever must be open.
You must remove the memory carrier because it attaches directly to the processor
board.
To avoid damage to the extraction handles, HP recommends rotating the handles
inward and snapping them into the locked position when servicing the system
DIMMs or any time the carrier is out of the chassis. Before replacing the memory
carrier assembly, press the button to release the extraction handles. Use the handles
to replace the memory carrier into the chassis.
Removal and Replacement
Removing and Replacing System Memory
91
Need help?
Do you have a question about the Integrity rx6600 and is the answer not in the manual?