Ilo 2 Mp; Figure 2-8 Core I/O Board Controls, Ports, And Leds - HP Integrity rx6600 User's & Service Manual

Controls, Ports, and LEDs
Rear Panel

iLO 2 MP

The server contains an iLO 2 MP on the core I/O board that enables local and remote management of the
server. The iLO 2 MP can function using standby power and is active when ac power is present and the front
panel power switch is off. The iLO 2 MP is also active when ac power is present and the front power switch is
on.
Figure 2-8 shows the controls, ports, and LEDs on the core I/O board. The figure is oriented vertically to
match the orientation of the core I/O board.
Figure 2-8 Core I/O Board Controls, Ports, and LEDs
iLO 2 MP RS-232 Serial Port
(M cable & RS-232 DB-9F to
DB-9F cable)
Connected to emulation
terminal device (PC, laptop,
or ASCII terminal)
USB 2.0 Ports
(any USB device)
VGA Port
No iLO 2 MP access;
EFI only
iLO 2 MP Reset Button
The iLO 2 MP reset button enables you to reset the iLO 2 MP, and optionally reset the user-specific values to
factory default values. To soft reset the iLO 2 MP, press the button momentarily, then release it. To soft reset
the iLO 2 MP and return user-specific values to factory default values, press the button for more than four
seconds, then release it. The following values are reset to factory default values:
• Serial terminal baud rate settings
• User names and passwords
42
General Use Serial Port
(Printers, etc.)
10 Base-T/100Base-T Mode LED
iLO 2 MP Access
Link And Activity LED
Standby Power
MP Self Test
MP Heartbeat
BMC Heartbeat
Chapter 2