Removal and Replacement
Removing and Replacing a Dual-Core Processor
Figure 4-19 Processor Board Assembly
Module 0
Step 6. Open the processor cage (Figure 4-19).
a. Grasp the processor cage handle, and apply adequate force to rotate the handle upward.
b. Use the handle to rotate the cage closure approximately 90 degrees toward the front of the
assembly until it stops.
IMPORTANT Ensure the processors are entirely exposed and can clear the cage closure for
Step 7. Disconnect the processor power cable from the connector cable that attaches directly to the
processor board (Figure 4-20).
Step 8. Unlock the processor from the socket on the processor board (Figure 4-22).
a. Unfasten the processor install tool (2.5 mm screwdriver) from the tool holder on the processor
board.
104
removal.
Module 1
Rear of Chassis
Chapter 4