Conconfig - HP Integrity rx6600 User's & Service Manual

# of
CPU Logical
Slot CPUs Speed
--- ------- ---------
0 1 1 GHz
1 1 1 GHz

conconfig

Use this command to configure the primary console and turn on other consoles for mirroring from the
firmware.
Syntax
conconfig [index][on|off|primary]
Parameters
Index Specifies index of console to set as primary
on Enables the specified console as a secondary console
off Puts console into "Not Configured" (NC) state
primary Sets the specified console as primary
Notes
• Primary console setting will take effect after reboot
• P in the status column indicates that the console is the primary.
• S in the status column indicates that the console is the secondary.
• NC in the status column indicates that the console is not configured.
• If a disabled console is set to primary, it will be enabled.
Example E-10 conconfig Command
To display current primary operating system console
Shell> conconfig
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC Serial
2 S Serial
3 P VGA
Example E-11 conconfig 2 primary Command
To change primary operating system console
Shell> conconfig 2 primary
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC Serial
2 P Serial
3 S VGA
Example E-12 conconfig 3 off Command
To disable a console
Appendix E
L3 L4
Cache Cache
Size Size (hex.)
---- ----- ------
3 MB None 1F/00
3 MB None 1F/00
Device Path
-----------
Acpi(PNP0501,0)
Acpi(HWP0002,0)/Pci(1|1)
Acpi(HWP0002,0)/Pci(4|0)
Device Path
-----------
Acpi(PNP0501,0)
Acpi(HWP0002,0)/Pci(1|1)
Acpi(HWP0002,0)/Pci(4|0)
Family/
Model Processor
Rev State
---- ----------
B2 Active
B2 Sched Deconf
Utilities
EFI/POSSE Commands
307