HP Integrity rx6600 User's & Service Manual page 264

Core I/O Card Utilities
HP 8 Internal Port SAS HBA (SAS Controller)
See rules for creating IM volumes and hot spare disks.
CAUTION
DELETE
The DELETE command sets the controller configuration to factory defaults. This command also deletes any
existing IR volumes.
Syntax cfggen <controller #> delete [noprompt]
Parameters
<controller #> A SAS controller number between 0 and 255.
[noprompt] Eliminates warnings and prompts.
Operation
After entering the DELETE command, the system prompts you and asks if you want to proceed with the
command. Enter Yes if you want to proceed.
DISPLAY
This DISPLAY command displays information about controller configurations: controller type, firmware
version, BIOS version, volume information, and physical drive information.
Syntax cfggen <controller #> display [filename]
Parameters
<controller #> A SAS controller number between 0 and 255.
[filename] Valid filename to store output of command to a file.
Sample Output
Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type
EFI BSD version
Firmware version
Channel description
Initiator ID
Maximum physical devices
Concurrent commands supported
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Volume ID
Status of volume
RAID level
Size (in MB)
Physical hard disks (Target ID)
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #63
Target on ID #1
Device is a Hard disk
Enclosure #
Slot #
264
: SAS1068
: 2.00.09.00
: 1.10.01.00
: 1 Serial Attached SCSI
: 63
: 62
: 511
: 2
: Okay (OKY)
: 1
: 34304
: 9 1
: 1
: 8
Appendix D