Replacing the Front Cover
To replace the front cover, perform the following steps:
Step 1. Align the tabs at the rear of the front cover with the corresponding slots in the chassis and fully
seat the tabs into the slots.
Step 2. Tighten the two thumbscrews securely.
Replacing the Front Bezel
To replace the front bezel, push the front bezel straight into the chassis until it snaps into place.
Inserting the Server into the Rack
To insert the server into the rack, perform the following step:
Step 1. Press the rail clips on either side of the server inward and push the server into the rack until it
stops.
Step 2. Replace the T-25 screws that fasten the server to the rack.
Chapter 2
Converting SCSI Configuration from Simplex to Duplex
Replacing the Removed Modules
25