Ioconfig - HP Integrity rx6600 User's & Service Manual

Utilities
EFI/POSSE Commands
Shell> conconfig 3 off
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC Serial
2 P Serial
3 NC VGA
Example E-13 conconfig 3 on Command
To enable a console
Shell> conconfig 3 on
CONSOLE CONFIGURATION
Index Status Type
----- ------ ----
1 NC Serial
2 P Serial
3 S VGA

ioconfig

Use this command to deconfigure or reconfigure I/O components or settings.
Syntax
ioconfig <fast_init | wol> <on|off>
Parameters
<fast_init> specify device connection policy setting
<wol> specify system wake-on-lan setting
<on|off> specify to configure or deconfigure a feature or component
Operation
The ioconfig file is used to retain information on system's I/O configuration across reboots. The ioconfig
file is created by insf at install time; and is modified by insf, rmsf, and ioscan when devices are added or
removed. The only purpose of the ioconfig file to maintain configuration information when the system is not
running.
Example E-14 ioconfig Command
Shell> ioconfig
Deconfigure or reconfigure IO components or settings
IOCONFIG [fast_init|wol [on|off]]
fast_init Specifies device connection policy setting
wol Specifies System Wake-On-LAN setting
on|off Specifies to configure or deconfigure a feature or component
Note:
1. If fast_init is enabled, firmware will connect only the minimum set of
devices during boot.
feature if failure occurs.
2. Any pending Wake-On-LAN request will not be cleared until reboot if
the setting is changed to disabled.
System will clear pending Wake-On-LAN requests each time the system
reboots if the setting is disabled.
308
Device Path
-----------
Acpi(PNP0501,0)
Acpi(HWP0002,0)/Pci(1|1
Acpi(HWP0002,0)/Pci(4|0)
Device Path
-----------
Acpi(PNP0501,0)
Acpi(HWP0002,0)/Pci(1|1)
Acpi(HWP0002,0)/Pci(4|0)
This feature might cause boot failure; disable this
Appendix E