Management Subsystem (Ilo 2 Mp/Bmc); Manageability Lan Led On The Core I/O Board Fru's Bulkhead; Manageability Reset Button On Core I/O Board Fru's Bulkhead; Manageability Status Led - HP Integrity rx6600 User's & Service Manual

Management Subsystem (iLO 2 MP/BMC)

Manageability LAN LED on the Core I/O board FRU's bulkhead

The manageability LAN uses two LEDs, viewable from the rear of the server. The manageability LAN LED
indicates link and activity status.
Only 10 Mb and 100 Mb speeds are currently supported on the manageability LAN.
Table 5-25 lists the manageability LAN LED statuses with their corresponding LED states.
Table 5-25 Manageability LAN LED States and Speeds
Link
Activity
Link with no activity
No link
100 MB
10 MB
NOTE For information on the Core LAN LED, see "I/O Subsystem (SAS/SATA/SCSI/DVD/HDD/Core
I/O)" on page 190.

Manageability Reset Button on Core I/O Board FRU's Bulkhead

The manageability reset button, with pinhole access from the rear of the server, allows you to reset the iLO 2
MP; it optionally also resets user-specified values to factory default values. A momentary press causes a soft
reset of the iLO 2 MP, when the button is released; a greater than four-second press effects the same end upon
release, and also returns user-specified values to factory default values (hard reset).
The crucial values to be reset are:
• Serial terminal baud settings
• User names and passwords

Manageability Status LED

The manageability status LED indicates the state and health of the iLO 2 MP. It is visible from the rear of the
server.
Chapter 5
LED State
Status
Blinking green
Solid green
Off
Speed
Solid amber
Off
Troubleshooting
Management Subsystem (iLO 2 MP/BMC)
189