Replacing The Interconnect Board; Figure 4-32 Interconnect Board Removal And Replacement - HP Integrity rx6600 User's & Service Manual

Removal and Replacement
Removing and Replacing the Interconnect Board
Step 14. Lift the interconnect board out of the chassis.
Figure 4-32 Interconnect Board Removal and Replacement
Connector to
Midplane Board

Replacing the Interconnect Board

To replace the interconnect board, follow these steps:
CAUTION Handle the interconnect board carefully, or you can damage the plastic insulator material on
the back of the board.
NOTE Use the guide posts located on the chassis and keyways located on the interconnect board to
help you with the interconnect board removal and replacement procedures.
Step 1. Place the interconnect board onto the guide posts.
Step 2. Insert your fingers into the board handle and push the board toward the rear of the chassis until it
plugs into the socket on the midplane board.
Step 3. Replace the lower SAS backplane. See "Replacing the SAS Backplane Board" on page 140.
Step 4. Replace the upper SAS backplane. See "Replacing the SAS Backplane Board" on page 140.
Step 5. Guide the interconnect board air baffle into the chassis and snap it into place.
142
Connector to
Display Board
Connector to SAS
Backplane Board
Connector to SAS
Backplane Board
Chapter 4