Replacing The Front Bezel; Removing The Air Duct - HP LP 1000r Service Manual

Hide thumbs Also See for LP 1000r:

Table of Contents

Chapter 6

NOTE

Replacing the Front Bezel

1. Place the bottom edge of the front bezel into the hinge pins at the bottom front of the chassis.

2. Rotate the top front of the bezel into place and push it in at the top, allowing it to snap into

place.

The spring latches grasp the pins at the top and hold the bezel in place.

The air duct directs air from the fan onto the heatsinks of both processors. The air duct also restricts access

to both processors and all the DIMMs, and must be removed for full access.

1. Loosen the two captive screws holding the air duct to the system board.

2. Remove the air duct from the system board.

The front bezel pivots on two pins at the bottom, and is held in place at the top with

spring latches holding onto the top pins. The middle pins limit bezel rotation to an

80 ° angle.

Front Bezel Location

Replacing Parts

Pins

Spring

Latch (2)

Table of Contents