Figure 1-5 Power Subsystem Block Diagram - HP Integrity rx6600 User's & Service Manual

Introduction
Power
Figure 1-5 Power Subsystem Block Diagram
Two hot-swappable ac/dc power supplies generate main system power and a standby power voltage. One
active power supply is sufficient to operate the system at maximum load. Each power supply receives ac
power through the integrated ac inlet. The system can operate at 180-264 VAC and achieve 1+1 redundancy.
The power supplies are power factor corrected and the maximum dc power output of the power system is 1600
watts. Service the hot-swappable power supplies by sliding them out the rear of the chassis.
26
Chapter 1