Replacing The I/O Vrm; Figure 4-25 Removing And Replacing The I/O Vrm - HP Integrity rx6600 User's & Service Manual

Step 6. Grasp the I/O VRM by the edges and lift it out of the chassis (Figure 4-25).
Figure 4-25 Removing and Replacing the I/O VRM
I/O VRM
Cover

Replacing the I/O VRM

To replace the I/O VRM, follow these steps:
Step 1. Insert the I/O VRM into the socket on the I/O board.
NOTE
a. Firmly and evenly push on each end of the I/O VRM until it seats into the slot.
b. Ensure that the extraction levers are in the closed position.
NOTE
Step 2. Place the I/O VRM cover on top of the I/O VRM and turn the knurled thumbscrew clockwise until
the cover tightens into place on the chassis wall (Figure 4-25).
Chapter 4
I/O VRM
The I/O VRM is keyed to fit into the socket in only one direction.
You may need to manually close the extraction levers.
Removing and Replacing the I/O Voltage Regulator Module
Knurled Thumbscrew
Removal and Replacement
Rear of Chassis
119