Dedicated Ilo Management Module - HP Apollo 4200 Gen9 Maintenance And Service Manual

Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
Enter the product ID and press the Enter key.
7.
Press the F10 key to confirm exiting System Utilities. The server automatically reboots.
8.

Dedicated iLO management module

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 17).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 27).
3.
Remove the access panel
4.
If installed, removed the rear drive cage:
5.
Disconnect all cables from the drive backplane:
a.
—
Disconnecting the cables from the four-bay LFF hot-plug rear drive cage connected to the front
drive cage 2 backplane
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Access panel" on page 36).
DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 111