Identification And Networking; Change Target Identification; Storage Manager - Defined Mutual Authentication Settings - IBM DS3000 Introduction And Implementation Manual

7065Admin_iSCSI.fm
Figure 12-7 Storage Manager - Defined mutual authentication settings

12.2 Identification and networking

Identification and networking allows you to configure the networking settings for the two iSCSI
ports on each controller, the target discovery method that can be used by initiators and an
alias for the subsystem.

12.2.1 Change Target Identification

Change Target Identification allows you to setup an alias name for the iSCSI storage
subsystem that can be seen in the iSCSI session information.
1. To setup an iSCSI target alias, click Change Target Identification.
2. Enter an alias name (DS3300 in our example in Figure 12-8), and click OK.
274
IBM System Storage DS3000: Introduction and Implementation Guide
Draft Document for Review August 30, 2007 12:59 am