Reset Battery Age; Change Network Configuration - Complete - IBM DS3000 Introduction And Implementation Manual

Draft Document for Review August 30, 2007 12:59 am
Figure 11-27 Change Network Configuration - Complete
7. Repeat this process for the second controller if required

11.3.3 Reset Battery Age

Each controller has a battery to protect the cache data in case of a power loss. Open this view
to monitor the age of your batteries (Figure 11-28 on page 266). If the batteries are nearly at
end of life, you will see an entry in the event log - contact IBM Support to replace the
batteries. After replacing the batteries you should reset the counter to start again for the new
batteries.
7065Admin_Tools.fm
Chapter 11. Administration - Tools
265