Change Target Discovery; Storage Manager - Change Target Identification; Storage Manager - Target Identification Changed - IBM DS3000 Introduction And Implementation Manual

Draft Document for Review August 30, 2007 12:59 am
Figure 12-8 Storage Manager - Change target identification
3. You will see a confirmation message like Figure 12-9. Click OK to return to the iSCSI tab.
Figure 12-9 Storage Manager - Target Identification changed

12.2.2 Change Target Discovery

We discussed techniques for target discovery in 1.3.2, "iSCSI discovery" on page 10. The
Change Target Discovery dialog can be used to specify if an Internet Storage Name Service
(iSNS) will be used to register this target for easier locating by iSCSI initiators. By default, the
Send Targets and Static methods are supported from the initiator to discover iSCSI targets.
An iSNS server can also be specified, using either its IPv4 or IPv6 address or by DHCP. If
using iSNS, your DHCP should be configured with option 43 (Vendor Specific Info) to inform
the DHCP client about the IP address of the iSNS server. See your DHCP server's
documentation for more information on how to configure this option.
1. To modify the discovery settings click Change Target Discovery.
7065Admin_iSCSI.fm
Chapter 12. Administration - iSCSI
275