Test Cluster Configuration - IBM DS3000 Introduction And Implementation Manual

Draft Document for Review August 30, 2007 12:59 am
Figure 18-67 Cluster network priority
9. The network usage configuration should now look as shown in Figure 18-67 on page 439.
Figure 18-68 Networks reconfigured
The cluster is now ready for testing.

18.13 Test cluster configuration

The cluster installation is done and should be tested. You should test that you can move
resources between the cluster nodes and that there is proper access to the shared drives in
the cluster on each node. You should also verify that failover works when each node goes
down. After all tests are successful proceed to install applications on the drives.
Chapter 18. iSCSI configuration 3 - Windows 2003 Cluster
7065iSCSI_Config3.fm
439