Completing the installation
After you install the hard disk drives and power supplies, follow the instructions in
this section to complete the installation. Instructions for installing the identification
labels and cabling the storage unit are included.
Installing identification labels
Your storage unit comes with one sheet of 10 labels (0-9) and one sheet of 4 labels
(SCSI ID) labels.
Complete the following steps to install the SCSI identification labels:
To install the label:
1. Locate the SCSI ID label for your configuration. Use the single-bus label as
16
5194 Network Attached Storage Model EXU Installation and User's Guide
illustrated below.
a. Orient the label so that the printed numbers are legible from left-to-right.
b. Peel the backing away from the adhesive side of the label.
c. Carefully butt the edge of the SCSI ID label up against the edge of the serial
number label so that the 14 printed ID numbers are located beneath each of
the drive bays.
d. Apply the label to the front of the unit, as shown in the following illustration.
0
1
2
3
4
5
Expansion unit ID label
6
8
9
10 11 12 13 14
Serial number label
SCSI ID label