Locate Storage Subsystem Or Enclosures - Stop; Locate Array - IBM DS3000 Introduction And Implementation Manual

7065Admin_Tools.fm
Draft Document for Review August 30, 2007 12:59 am
The lights on the selected component will start flashing. After you have located it click Stop
(Figure 11-13) to disable the flashing and click Close to return to the Locate view
(Figure 11-11).
Figure 11-13 Locate Storage Subsystem or Enclosures - Stop
Locate Arrays
Click this link to open the Locate Arrays view (Figure 11-14 on page 255). Select the array
you want to locate and click Locate. The lights on the disk drives in the array will start
flashing. Click Stop to disable the flashing and Close to return (Figure 11-11).
Figure 11-14 Locate Array
Locate Drives
Click Locate Drives to display the window shown in Figure 11-15 on page 256. Select the
drive(s) you want to locate and click Locate. The drive lights will start flashing. With Stop and
Close you can again disable the flashing and return to the Locate view (Figure 11-11).
255
Chapter 11. Administration - Tools