Configure Storage Subsystem - Automatic - IBM DS3000 Introduction And Implementation Manual

7065DS3KBasicConfig.fm
Draft Document for Review August 30, 2007 12:59 am
Figure 4-35 Configure storage subsystem - automatic
Automatic configuration
As stated, this is a one-click way to set up the arrays and logical drives. The only parameter
you need to specify is the RAID level - Storage Manager will then group any unconfigured
physical disk drives into arrays and carve the arrays into logical drives. Figure 4-36 shows an
example of an automatic configuration.
In the pulldown, select the RAID level - from 0, 1, 3, or 5.
To select RAID 10, select 1 - if there are at least 4 drives in the array, then RAID 10 will be
automatically used.
73
Chapter 4. Basic configuration