IBM DS3000 Introduction And Implementation Manual page 507

Draft Document for Review August 30, 2007 12:59 am
2. Click Next and you are prompted which disks to initialize (Figure 20-12 on page 475). By
default all newly discovered disks are displayed. Mark all disks you want to initialize and
click Next.
Figure 20-12 Select disks to initialize
3. If you want to convert one of the disks to a dynamic disk mark it here and click Next
(Figure 20-13). However, dynamic disks are not supported for MSCS so we will not do this.
Figure 20-13 Select disks to convert
4. The Completing the Initialize and Convert Disk Wizard shows you a summary of your
selections (Figure 20-14 on page 476). Review them and click Finish to complete the
tasks.
Chapter 20. FC configuration 2 -BladeServer Microsoft Cluster
7065FC_Config2.fm
475