IBM DS3000 Introduction And Implementation Manual page 475

Draft Document for Review August 30, 2007 12:59 am
Figure 19-2 Blade Center Sample Configuration
At first, cable your environment as shown in Figure 19-2 so that it provides redundancy.
After the cabling we will zone the switches for our SAN. Our sample configuration uses
McData 4GB Blade Center FC Switches. Log on to one of the Blade Center FC Switches and
highlight the switch to display the associated view (Figure 19-3).
Note: A detailed description of Blade technology and how to manage it is beyond the
scope of this book. You can find information on the IBM Blade Center how to access the
switch modules in:
Advanced Management Module and Management Module User's Guide - IBM
BladeCenter MIGR-45153
http://www-304.ibm.com/jct01004c/systems/support/supportsite.wss/docdisplay?lndocid=
MIGR-45153&brandind=5000020
Chapter 19. FC configuration 1 - Emulex HBA boot BladeServer from SAN
7065FC_Config1.fm
443