Radiator - Remove And Install - Volkswagen Fox 2004 Workshop Manual

Without Cooling system supply unit VAS 6096 -VAS 6096- :
– Fill with coolant up to the maximum mark on the expansion
reservoir.
– Replace the coolant reservoir cover.
– Turn off heating start device.
– Start engine and maintain an speed of about 2000 rpm for ap‐
prox. 3 minutes.
– Run engine until the radiator fan starts.
– Check coolant level and, if necessary, replenish. With engine
hot, the coolant level shall be on max. marking; with engine
cold, it must be between the max. and min. marks.
1.5

Radiator - remove and install

Special tools and workshop
equipment required
♦ Refractometer for cooling
system fluid analysis -
T10007-
♦ Tray -V.A.G 1306-
♦ Torque wrench - 5 to 50 Nm
( enc. 1/2") -VAG 1331-
♦ Standart-type clamp pliers -
VAS 5024A-
1.5.1 Removal
– Remove front bumper ⇒ Rep. Gr. 63 .
– Put front panel in the work position: ⇒ Rep. Gr. 50 .
– Drain the cooling system ⇒ page 76 .
3 - Cyl. diesel engine - Edition 02.2009
1. Cooling system components - remove and install
Fox 2004 ➤
79