Note
Since the lifting eyes are located on the cylinder head, an addi‐
tional support should be fastened to the engine block for removing
the cylinder head.
– Fit Support bracket -10-222A- as shown and support the en‐
gine in its installation position.
– Carefully lift the engine slightly with spindle -A-.
– Attach Retainer -T10014- to engine block using the threaded
hole in the vicinity of water pump, as illustrated. Tightening
torque: 20 Nm.
– Lift engine slightly using second spindle -B- until spindle -A- is
relieved.
– Remove spindle -A-.
– Before removing cylinder head, drain fuel at auxiliary pump
using Manual vacuum pump -V.A.G 1390- with the Fluid re‐
ceptacle -V.A.G 1390/1-
– Follow the sequence indicated when loosening or tightening
the cylinder head screws.
⇒ page 97
.
3 - Cyl. diesel engine - Edition 02.2009
1. Cylinder head - remove and install
Fox 2004 ➤
47