Volkswagen Fox 2004 Workshop Manual page 23

– Remove crankshaft gear. To do this, immobilise gear with the
Lock -3415- .
– To guide the seal Extractor -3203- , install the gear fastening
screw manually up to the crankshaft stop.
– Give the inside part of the Extractor -3203- two turns (approx.
3 mm) from the external side, and lock with the slotted bolt.
– Lubricate the threaded head of the oil seal Extractor, -3203-
install and screw as firmly as possible onto the seal.
– Loosen the slotted screw and turn the inner part against the
crankshaft until the seal is extracted.
2.1.2 Installation
Note
Do not apply additional lubricant or grease to the sealing lip of the
oil seal.
– Before installation, remove oil residues from crankshaft trunn‐
ion with a clean cloth.
– Fit the Guide sleeve -T10053/1- onto the crankshaft trunnion.
– Slide oil seal over the Guide sleeve -T10053/1- and over the
end of the crankshaft.
3 - Cyl. diesel engine - Edition 02.2009
2. Crankshaft flanges and flywheel - remove and install
Fox 2004 ➤
19