Volkswagen Fox 2004 Workshop Manual page 26

Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
– Cut the tube injector on front marking (∅ of injector is approx.
3 mm) .
– Apply silicone sealant, as shown, on the clean sealing surface
of the sealing flange. The sealing compound bead must:
♦ Have a thickness of -arrows-: 2...3 mm.
Note
The sealant bead cannot be thicker, otherwise, the excess
♦
sealant could pass to the crankshaft and block the strainer of
the oil suction tube, as well as run along the sealing surface
of the oil seal in the crankshaft.
Before applying the sealant, cover the oil seal with a clean
♦
cloth.
– Fasten the sealing flange immediately and lightly tighten all
screws.
Note
Use the Guide sleeve -T10053/1- to fit the sealing flange with the
oil seal already installed.
– Tighten fastening screws of sealing flange by using an alter‐
nating tightening sequence. Tightening torque: 15 Nm.
– Remove excess sealant.
– Install crankcase ⇒ page 68
Note
After installation, the sealant should dry for approx. 30 minutes
before replenishing the engine with oil.
Install timing belt and adjust distribution times
– Install Poly-V belt ⇒ page 14
22
Rep. Gr.13 - Crankshaft, pistons
.
⇒ page 41
.
.