– Loose hub fastening screw -1-.
– Use Blocking device -T10051- .
– Loosen hub securing screw about 2 turns.
– Install Puller -T10052- and align it with holes in hub.
– Install securing screws -1- into hub.
– Apply effort to the hub by tightening evenly screw -2- until the
hub is separated from the tapered section of the camshaft.
Note
Hold puller with a spanner while doing the above operation.
– Remove the camshaft hub.
– Remove cylinder head cover.
– Remove injector drive arm shaft.
Note
First, loosen the outer securing bolts, then one bolt of each pair
of inner securing bolts, and lastly the other bolt of each pair.
– Remove auxiliary pump
– First, remove bearing caps 2 and 3. Then, loosen bearing caps
1 and 4 alternately and diagonally.
Note
Bearing cap 4 is identified as bearing cap 5.
2.4.2
Installation
Note
When installing the camshaft, the cams for cylinder 1 should
♦
point upwards.
Do not interchange used bearing shells (mark them).
♦
When installing the camshaft, ensure the proper clip seating
♦
on the bearing caps and cylinder head.
Before installing bearing caps, ensure that cylinder head bolt
♦
washers are fitted in the cylinder head.
– Lubricate contact surfaces of shell bearings.
⇒ page 97
.
3 - Cyl. diesel engine - Edition 02.2009
2. Valve command - repair
Fox 2004 ➤
59