Volkswagen Fox 2004 Workshop Manual page 73

– Cut the tube injector on front marking (∅ of injector is approx.
3 mm) .
– Apply silicone sealant, as shown, onto crankcase clean seal‐
ing surface. Sealing cord shall:
♦ Be 2...3 mm thick.
♦ Run on inside of bolt holes region -arrows-.
Note
Sealing cord may not be thicker, otherwise excess sealant may
drop into crankcase and block suction tube strainer.
– Install crankcase immediately and slightly tighten all the bolts.
Note
Crankcase shall be aligned with engine block.
– Tighten bolts to 15 Nm.
– Install transmission ⇒ Rep. Gr. 34 .
– Tighten crankcase/transmission screws to 45 Nm.
Note
After installing the crankcase, the sealant should dry for approx‐
imately 30 minutes before replenishing with engine oil.
3 - Cyl. diesel engine - Edition 02.2009
1. Lubrication system components - remove and install
Fox 2004 ➤
69