Volkswagen Fox 2004 Workshop Manual page 17

1 - 45 Nm
2 - Engine bracket
3 - Engine block
❑ Removing and installing
sealing flange and fly‐
wheel ⇒ page 17
❑ Disassemble and as‐
semble pistons and con‐
necting rods
⇒ page 32
4 - Connection, 40 Nm
❑ To turbocharger oil re‐
turn pipe .
❑ Replace.
5 - Spacer sleeve
6 - Rubber bushing
7 - Engine and gearbox sup‐
port
❑ To the Sensor Hall -
G40- connector of the
camshaft position and
Engine speed sensor -
G28- .
8 - 10 Nm
9 - Gasket
❑ Replace.
10 - Oil filter bracket
❑ Disassemble and as‐
semble ⇒ page 64
11 - 15 Nm + 90°
❑ Replace after each re‐
moval.
❑ First, install upper left and lower right bolts, then tighten the four bolts diagonally.
12 - Sealing ring
❑ Replace.
13 - 20 Nm
14 - Engine speed sensor -G28-
15 - Connection
❑ To temperature sensor.
16 - 15 Nm
17 - Coolant temperature sensor
❑ Remove and install
18 - 45 Nm
❑ Torque sequence: from inside out.
19 - Compact bracket
❑ To alternator, air conditioning compressor and Poly-V belt tensioning element.
❑ See the locating guide between compact bracket and engine block.
20 - Tensioning element
❑ To Poly-V belt.
.
.
⇒ page 82 .
3 - Cyl. diesel engine - Edition 02.2009
1. Engine - dismantle and assemble
Fox 2004 ➤
13