Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
– Lay chain over crankshaft sprocket, oil pump sprocket and
counterbalance shaft sprocket. Make sure that the marks on
the crankshaft sprocket and counterbalance sprocket align
with the colour-coded chain links -arrows-.
Note
The colour-coded chain links are marked with a notch.
– Fit the free sprocket in the chain and tighten the free sprocket
to the mounting frame. Tightening torque: 20 Nm.
– Remove Locking pin -T10060- from chain tensioning element.
– Make sure that the marks on the crankshaft sprocket and
counterbalance shaft sprocket align with the colour-coded
chain links -arrows-.
Note
The colour-coded chain links are marked with a notch.
– Install pulley end sealing flange
– Install counterbalance shaft cover. Tightening torque: 5 Nm.
Note
Before installing cover, lubricate O-ring of oil pump, as well as
♦
shaft on inside of cover
Make sure of the proper seating of sealing strip in cover.
♦
When installing cover, ensure that cover engages in mounting
♦
frame.
– Install crankcase
⇒ page 68
– Install and adjust timing belt
– Install Poly-V belt
⇒ page 14
28
Rep. Gr.13 - Crankshaft, pistons
⇒ page 17
.
.
⇒ page 41
.
.