Volkswagen Fox 2004 Workshop Manual page 42

Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
1 - Mechanical distribution up‐
per cover
2 - Timing belt
❑ Before removing, mark
operation direction.
❑ Check wear.
❑ Do not bend.
❑ Remove, install, and ad‐
just ⇒ page 41 .
3 - 10 Nm
4 - 25 Nm
5 - 100 Nm
6 - Camshaft gear
7 - Pulley
❑ With engine phase sen‐
sor wheel.
❑ Use Counter-hold tool -
T10051- to loosen and
tighten.
❑ To remove, use the Pull‐
er -T10052- .
❑ Remove and install
⇒ page 58 .
8 - Mechanical distribution rear
cover
9 - Sealing ring
❑ Replace if damaged.
10 - Hall Sensor -G40-
❑ To the camshaft posi‐
tion.
❑ To remove, remove
sealing ring.
11 - Cylinder head securing bolt
❑ Replace.
❑ Check the sequence when loosening or tightening
❑ Before installing, set washers in cylinder head.
12 - Pin 10 Nm
❑ To engine cover.
13 - Cylinder head cover
❑ With oil filler nozzle.
❑ Replace oil filling nozzle if cylinder head cover is damaged.
❑ Before installing, carefully clean the cylinder head sealing surface with a clean cloth.
14 - To turbocharger
15 - 10 Nm
❑ First hand tighten all bolts.
❑ Then tighten both top bolts and thereafter the remainder from the inside outwards, diagonally, according
to the specified tightening torque.
16 - Pressure regulating valve
❑ To crankcase vent.
38
Rep. Gr.15 - Cylinder head, valve control mechanism
⇒ page 46 .