Volkswagen Fox 2004 Workshop Manual page 66

Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
1 - 15 Nm
2 - Flange
❑ With sealing ring.
❑ Must be located on se‐
curing guides.
❑ Remove and install
⇒ page 17 .
❑ Install with Silicone
sealant -D 176 404 A2 -
⇒ page 17
❑ Do not apply additional
lubricant or grease to
the seal lip.
❑ Before installation, re‐
move oil residues from
crankshaft trunnion with
a clean cloth.
❑ Replace cranckshaft oil
sealing - pulley end
⇒ page 17 .
3 - Engine block
4 - Gasket
❑ Replace.
5 - Oil filter bracket
❑ Disassemble and as‐
semble ⇒ page 64
6 - 15 Nm + 90°
❑ Replace after each re‐
moval.
❑ First, fit upper left and
lower right bolts; then,
tighten the four bolts di‐
agonally.
7 - Oil dipstick
❑ The oil level should exceed the maximum marking!
❑ Marks ⇒ page 66
8 - Guide
❑ Remove to drain oil.
9 - 5 Nm
10 - Guide tube
11 - 10 Nm
❑ Not applicable.
12 - Sealing ring
❑ Replace.
❑ Check it is securely seated.
❑ Lubricate lightly when fitting.
13 - Cover
❑ With sealing tape.
❑ Clean filter if dirty.
62
Rep. Gr.17 - Lubrication system
.