Crankshaft Flanges And Flywheel - Remove And Install - Volkswagen Fox 2004 Workshop Manual

2 Crankshaft flanges and flywheel - re‐
move and install
Note
Clutch repairs: ⇒ Rep. Gr. 30 .
WARNING
Always replace self-locking nuts and screws subject to angular
torque
1 - Seal
❑ Do not apply additional
lubricant or grease to
the seal lip.
❑ Before installation, re‐
move oil residues from
crankshaft trunnion with
a clean cloth.
❑ Replace crankshaft oil
seal - pulley side
⇒ page 18
2 - Sealing flange
❑ Must be positioned on
the fixing guides.
❑ Remove and install
⇒ page 20 .
❑ Install with Silicone seal
-D176404 A2-
⇒ page 20 .
3 - Engine block
❑ Removing and installing
crankshaft ⇒ page 29
❑ Disassemble and as‐
semble pistons and con‐
necting rods
⇒ page 32
4 - Engine flywheel
❑ To remove and install
the flywheel, immobilise
with the Flywheel lock
-3386-
5 - 60 Nm + 90°
❑ Replace after each re‐
moval.
6 - Intermediate plate
❑ Must be positioned on fixing guides.
❑ Do not damage / bend during assembly
7 - 15 Nm
8 - Sealing flange with seal
❑ Complete replacement only.
3 - Cyl. diesel engine - Edition 02.2009

2. Crankshaft flanges and flywheel - remove and install

Fox 2004 ➤
17