Volkswagen Fox 2004 Workshop Manual page 106

Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
Note
All the hoses are fastened with clamps or coupling fittings.
♦
When installing spring clamps, use Standart-type clamp pliers
♦
-VAS 5024A- .
Do not install hoses containing lubricant on its connections.
♦
Overcharge system must be free of leaks.
♦
Before installing the oil supply pipe, fill the turbocharger,
♦
through the connection point, with engine oil.
After installing the turbocharger, run the engine during at idle
♦
speed for about 1 minute. Do not accelerate the engine. This
will ensure the turbocharger is properly lubricated.
Always replace self-locking nuts.
♦
Hoses with coupling connections
Note
All the overcharge system hoses are fastened with spring clamps
or connections. Always check the following points in the connec‐
tions:
– Release the connection by pulling the fixing clip -arrow-, with‐
out using tools.
– When assembling, make sure the retaining tabs -A- are firmly
secured.
102
Rep. Gr.21 - Overcharge - turbo