Volkswagen Fox 2004 Workshop Manual page 9

– Release the radiator cooling system hoses from the engine by
using Hose clamp pliers -V.A.G 1921- or Standart-type clamp
pliers -VAS 5024A- .
– Remove/disconnect all the electric connections from the en‐
gine where necessary.
– Remove all the cooling, vacuum and intake system hoses from
the engine.
– Remove securing bolt of the cable support bracket and secure
clutch release lever by inserting a Locking pin -T10060 A-
-arrow-.
– Remove securing bolts from the top of engine/gearbox.
– Remove cooling fluid container.
– Unbolt starter motor and move it back until the Support -3147-
can be inserted.
– Install the Support bracket -10-222A- and support engine and
gearbox as shown in diagram.
– Remove engine support -1- and engine console -2-.
– Disconnect right-hand drive shaft⇒ Rep. Gr. 40 .
– Loosen front exhaust pipe from turbocharger. Loosen double
clamp and push exhaust pipe backwards
– Remove the protection plate behind the drive shaft flange.
Vehicles with air conditioning:
– For removal, refer to the additional information and instruc‐
tions ⇒ page 8 .
3 - Cyl. diesel engine - Edition 02.2009
⇒ page 118 .
Fox 2004 ➤
1. Engine - remove and install
5