Default/Reset/Save - Microscan MS-2 User Manual

Default/Reset/Save

Default/Reset/Save

Understanding and controlling your MS-2's active, saved, and default settings is critical to
its successful operation.
Reset
Save Current Settings for Power-On
Recall Microscan Default Parameters and
Save for Power-On
a. When you right-click in a menu tree and select Default Current Menu Settings or Default
All ESP Settings, it is important to note that only ESP settings are defaulted. To save these
defaults to the MS-2 itself, you need to follow up with a Save to Reader, Send and Save
command.
Reset
Reset ("A" command) affects only current settings (active memory) and does not save for
power-on.
Save for Power-On
Power-on parameters ("Z" commands) are saved, recalled, and loaded into current parameters
when power is cycled to the MS-2.
Important: The following commands must be followed by a
Host Protocol, Baud Rate, Data Bits, Stop Bits, Parity, Trigger Characters (Delimited,
Start, Stop), Preamble, Postamble, and No Read Message.
All other parameters are saved for power-on without a <Z>. However, a
parameters.
7-8
Function
ESP (first, right-click in any
Serial Cmd
Save to Reader,
<A>
Save to Reader,
<Z>
Send and Save
<Zrd>
<Z> to be saved for power-on:
MS-2 CCD Reader User's Manual
a
menu tree)
Send No Save
No
<Zrd> affects all