Installing the Keyboard
To install the computer's keyboard, follow the steps below and refer to Figures 4-10 and 4-11.
1. Connect the keyboard cable to the pressure-plate connector on the system board (Figure
4-10).
2. Seat the keyboard in the computer. Note that a fold is built into the keyboard cable. Do
not try to bend the cable at any other point when you install the keyboard (Figure 4-9).
3. Install the top cover, optional PCMCIA card, optional memory card and battery pack as
described in Sections 4.5 through 4.2.
Figure 4-11 Seating the Keyboard
4-13