COPY Program
1. When COPY is selected, the following message appears:
FLOPPY DISK FORMAT & COPY : VX.XX
Type select (0:2DD-2DD,1:2D-2D,2:2D-2HD,3:2HD-2HD) ?
2. Selecting a media/drive type number will display a message similar to the one below:
Insert source disk into drive A:
Press any key when ready.
3. Remove the Diagnostics Disk from the FDD, insert the source disk and press any key.
The following message will appear, indicating the program has started.
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = XX
Copy start
4. Remove the source disk from the FDD, insert a formatted work disk and press any key.
The [[ track, head = XXX X ]] message will appear and start copying to the target disk.
When the amount of data is too large to be copied in one operation, the message from
Step 2 is displayed again. After the floppy disk has been copied, the following message
will appear:
Copy complete
Another copy (1:Yes/2:No) ?
5. To copy another disk, select 1 and the message from Step 1 will be displayed again.
Entering 2 returns the test program to the DIAGNOSTIC MENU.
DUMP Program
1. When DUMP is selected, the following message appears:
DIAGNOSTICS-HARD
Drive type select (1:FDD, 2:HDD) ?
2. Select a format type number. If 2 is selected, the display will go to the step (5).
= XXX
= X
[[ track,head
DISK & FLOPPY DISK DUMP : VX.XX
=
XXX X ]]
3-47